[patch 00/12 v4] kexec kernel efi runtime support (no replies)

Hi,

Sorry for the spam, the patch subject is not correct in previous
sending a while ago, send them again..

Here is the V4 for supporting kexec kernel efi runtime.
Per pervious discussion I pass the 1st kernel efi runtime mapping
via setup_data to 2nd kernel. Besides of the runtime mapping
info I also pass the fw_vendor, runtime, config table, smbios
physical address in setup_data. EFI spec mentioned fw_vendor,
runtime, config table addresses will be converted to virt address
after entering virtual mode, but we will use it as physical address
in efi_init. For smbios EFI spec did not mention about the address
updating, but during my test on a HP workstation, the bios will
convert it to Virt addr, thus pass it in setup_data as well.

For fw_vendor, runtime, config table, I export them in /sys/firmware/
efi/, smbios is already in /sys/firmware/efi/systab.

For efi runtime mapping I add a new directory /sys/firmware/efi/
runtime-map/ like below
[dave@darkstar ~]$ tree /sys/firmware/efi/runtime-map/
/sys/firmware/efi/runtime-map/